How much does fog affect solar panels?
Wondering if your solar panels will work on foggy days? They will, just at lower power (around 30–70% less).
The good news is UK fog tends to clear pretty quickly.
- Yes, panels work in fog. They generate from the diffuse daylight that filters through, at a reduced rate.
- Dense fog bites hard. Hour for hour it can take nearly as much off as heavy overcast, cutting output by around 30 to 70%.
- It’s usually temporary. Morning fog tends to burn off as the sun climbs, and output recovers.
- The yearly impact is small. UK fog is passing and localised, and yield estimates already account for it.
- It does no harm. Fog only dims the light; it doesn’t damage panels or settle on them like snow.
Do panels work in fog?
Yes. Solar panels run on light, not on direct sunshine specifically, and fog doesn’t block light so much as scatter it. Fog is a cloud of tiny water droplets suspended near the ground, and when sunlight meets it, the droplets bounce the light around in all directions. What reaches your panels is mostly diffuse light, softer and coming from everywhere rather than straight from the sun, but it still carries the photons that trigger the photovoltaic effect. So the panels keep working, converting that scattered daylight into electricity, just less efficiently than under a clear sky.
It’s the same principle that keeps panels generating on an overcast day, which is why solar is viable across cloudy northern climates at all. Fog is simply the same thing at eye level instead of overhead. The panels don’t know or care that the droplets are close to the ground rather than a mile up; they respond to the light that gets through.
- Diffuse light
- Sunlight scattered in all directions by cloud, fog or atmosphere, rather than arriving as a direct beam. Panels still use it.
- Direct (beam) radiation
- Sunlight arriving straight from the sun. Fog cuts this the most, leaving mainly diffuse light.
- Irradiance
- The intensity of light hitting the panels. Fog lowers it, which is why output falls.
- Photovoltaic effect
- How a panel makes electricity: photons of light knock electrons loose in the cells. Diffuse photons work too.
How much does fog cut output?
It depends heavily on how thick the fog is, but dense fog takes a real bite. In heavy fog, the light reaching the panels can fall by roughly 30 to 70% compared with a clear day, so your system might be running at anywhere from a third to two-thirds of its clear-sky output, sometimes less in the very thickest conditions. Light fog or mist takes far less off, and as the fog thins the output climbs back up.
Hour for hour, dense fog at its thickest can take nearly as much off as a heavy overcast sky. The difference is duration: fog is usually brief, where cloud can sit all day. A sharp dip that lasts an hour or two matters far less than a moderate dip that lasts from dawn to dusk.
Fog vs cloud, rain and snow
It helps to see where fog sits among the weather people worry about. The short version: anything that’s still daylight lets the panels work; only settled snow and true darkness stop them.
| Condition | Effect on output |
|---|---|
| Clear sun | Full output |
| Light cloud | Around 60-80% |
| Dense fog | Around 30-70%, but usually brief |
| Heavy overcast | Around 10-25% |
| Rain | Reduced, and it cleans the panels |
| Settled snow | Can block panels until it clears |
| Night | Zero |
- Clear sunFull output
- Light cloudAround 60-80%
- Dense fogAround 30-70%, but usually brief
- Heavy overcastAround 10-25%
- RainReduced, and it cleans the panels
- Settled snowCan block panels until it clears
- NightZero
The contrast that matters is fog against snow. Fog dims the light but lets some through, with almost no reflection to make up for it, so it just just lowers output for a while. Settled snow is different in kind: it physically covers the cells and blocks the light entirely until it slides or melts off, though a clear, snow-covered landscape can reflect extra light onto panels once they’re uncovered. Rain behaves much like cloud and has the bonus of washing the panels clean. And night is the only condition that stops generation completely, because there’s no light at all (moonlight doesn’t work), as covered in our guide to whether solar panels work at night.
Morning fog burns off
Here’s the reason fog is rarely a real problem for your yearly generation: it doesn’t last. Most fog is a morning phenomenon that forms overnight and lifts as the sun climbs and warms the ground, often clearing entirely by mid-morning, though in the depths of winter, especially in valleys, it can hang around all day. So a foggy start usually gives way to a productive day, and your panels make up much of the early shortfall once the sun breaks through.
That timing works in your favour. The foggiest part of the day, early morning, is also when the sun is low and your panels would be generating least anyway, so the overlap between “foggy” and “peak generating hours” is small. By the time the panels would be hitting their midday stride, the fog has usually gone. The dip is real, but it lands at the cheapest time of day.
The UK picture, and what helps
Britain gets its share of fog, especially on autumn and winter mornings, in valleys, near rivers and along some coasts. But because it’s typically brief and localised, its effect on annual output is minor, and it’s already baked into any realistic yield estimate: professional forecasts are built from long-run solar-resource data for your location, which captures the local pattern of fog, cloud and sun over a whole year, not from optimistic clear-sky figures. The fog you get has already been counted.
There’s little you can do about fog specifically, and little you need to, but a few choices help a system make the most of dim conditions generally.
- Good monocrystalline panels with strong low-light performance capture diffuse daylight more effectively than budget alternatives.
- A battery smooths things out, storing surplus from bright spells to cover the dips, foggy mornings included.
- A well-oriented, unshaded array makes the most of whatever light is available, direct or diffuse.
- Clean panels matter more than the weather; dirt and debris cost output every day, not just foggy ones.
For the broader picture of solar under grey British skies, see our guide to how solar panels perform on cloudy days, the dominant weather variable in the UK.
Frequently asked questions
Do solar panels work in fog?
Yes. Fog scatters light rather than blocking it, so panels keep generating from the diffuse daylight that filters through, just at a reduced rate. Output falls but doesn’t stop, and it recovers as the fog thins.
How much does fog reduce solar output?
In dense fog, the light reaching the panels can drop by roughly 30 to 70%, so output runs at about a third to two-thirds of a clear day, sometimes less. Light fog or mist takes far less off, and output climbs as the fog clears.
Is fog worse for solar than cloud?
Hour for hour, dense fog can be nearly as bad as a heavy overcast sky. But fog is usually brief and clears during the morning, while cloud can last all day, so over time fog costs far less generation than persistent overcast.
Does fog damage solar panels?
No. Fog only dims the available light; it doesn’t harm panels, which are built for all weather. Unlike snow, fog doesn’t settle on or cover the panels, so there’s nothing to clear. Output simply returns to normal once the fog lifts.
Will fog affect my yearly solar generation much?
Not much. UK fog is typically a passing morning event, and it usually clears before the panels reach their most productive hours. Its effect on annual output is small and already included in professional yield estimates for your location.
Dimmed for an bit, not switched off
Solar panels work in fog. They generate from the scattered, diffuse daylight that filters through, and while dense fog can cut output by around 30 to 70%, it doesn’t stop generation and does no harm.
Best of all, fog is usually a passing morning affair that burns off before your panels reach their most productive hours, so its toll on your yearly generation is small, and already counted in any realistic yield estimate.
Only settled snow and true darkness actually stop a panel. Fog just asks it to work a little more quietly for a while.
SOURCES: Fog formation, UK seasonality and morning clearance per the Met Office and the Royal Meteorological Society’s MetLink. Dense fog cutting light to panels by roughly 30 to 70% per installer guidance; cloudy-day output ranges per UK and international installer data; rain keeping panels clean per University of Brighton research on weather and PV efficiency in south-east England (Ghazi and Ip, Renewable Energy, 2014). Annual yield modelling per the European Commission’s PVGIS and the standard MCS performance estimate. Figures are typical and vary by fog density, location, season and system.
DISCLAIMER: This guide is general information about solar performance, not system-design advice. Actual generation depends on your location, weather patterns and system. For a realistic yield estimate, consult an MCS-certified installer using long-run solar-resource data.
UPDATED & FACT-CHECKED: 15 October 2026.